I tried following instructions at: How to install a kernel from my repo onto Edison with the official image and have wound up stuck after reboot. The device seems stuck in a loop until any key is pressed and just repeats as below. When I hit a key I wind up at a "boot>" prompt and cannot exit back to the command line. Can you advise on how to get out of this state and back to where I was? Thanks! -C
Target:blank
Partitioning already done...
Flashing already done...
GADGET DRIVER: usb_dnl_dfu
reading vmlinuz
** Unable to read file vmlinuz **
Error: Invalid Boot Flag (found 0xffef, expected 0xaa55)
## Kernel loading failed ...
zboot - Boot bzImage
Usage:
zboot [addr] [size] [initrd addr] [initrd size]
addr - The optional starting address of the bzimage.
If not set it defaults to the environment
variable "fileaddr".
size - The optional size of the bzimage. Defaults to
zero.
initrd addr - The address of the initrd image to use, if any.
initrd size - The size of the initrd image to use, if any.
Unknown boot mode: boot
Saving Environment to MMC...
Writing to redundant MMC(0)... done
Resetting to default boot mode and reboot...
resetting ...
******************************
PSH KERNEL VERSION: b0182727
WR: 20104000
******************************
SCU IPC: 0x800000d0 0xfffce92c
PSH miaHOB version: TNG.B0.VVBD.0000000c
microkernel built 23:15:13 Apr 24 2014
******* PSH loader *******
PCM page cache size = 192 KB
Cache Constraint = 0 Pages
Arming IPC driver ..
Adding page store pool ..
PagestoreAddr(IMR Start Address) = 0x04899000
pageStoreSize(IMR Size) = 0x00080000
*** Ready to receive application ***
U-Boot 2014.04 (Oct 14 2014 - 15:19:04)
Watchdog enabled
DRAM: 980.6 MiB
MMC: tangier_sdhci: 0
In: serial
Out: serial
Err: serial
Hit any key to stop autoboot: 0
boot >